Metal saw blade binding machine, this seemingly inconspicuous mechanical equipment, actually plays an important role in our daily life.

So it is also important to perform regular maintenance on metal saw blade binding machine.

I. Cleaning work should be in place

Before starting the machine or after get off work every day, remember to use an air gun to clean up the waste chips in the mold. It is particularly important to note that the paper scraps in the saw blade must be cleaned up, otherwise it will affect the service life of the saw blade.

II. Check whether there are foreign objects in the mold

Before starting the machine, carefully check whether there are metal foreign objects in the mold. If there are, be sure to clean them up to avoid damaging the mold.

III. Lubricate moving parts

For moving parts, such as 4 guide pillars, spray some WD40 anti-rust oil to ensure that the guide pillars are lubricated and reduce wear. But be careful not to use excessive lubricating oil to avoid contaminating the material.

IV. Regular cleaning + maintenance

Perform deep cleaning once a week or month, especially for hard-to-reach areas. Fine dust particles can be blown away with a soft brush or air gun.

V. Tightening Check

Check the screws and other fasteners regularly to see if they are tight. If necessary, re-tighten to ensure the stability of the machine.

VI. Functional Test

Test the machine's functions regularly to confirm that the saw blade is firmly and reliably bound. Check for any jamming or abnormal sounds.

VII. Adjustment and Calibration

Adjust the position of the saw blade as needed to ensure good cutting results. Adjust the machine's pressure settings to ensure binding quality.

VIII. Safety First

Before performing any maintenance or cleaning, always turn off the power and unplug the plug to ensure safety.